A flexure bearing is a bearing which allows motion by bending a load element. A bearing is a device to permit constrained relative motion between two parts typically rotation or linear movement
A typical flexure bearing is just one part, joining two other parts. For example, a hinge may be made by attaching a long strip of a flexible element to a door and to the door frame. Another example is a rope swing, where the rope is tied to a tree branch.
Flexure bearings have the advantage over most other bearings that they are simple and thus inexpensive. They are also often compact, light weight, have very low friction, and are easier to repair without specialized equipment. Flexure bearings have the disadvantages that the range of motion is limited, and often very limited for bearings that support high loads.
A flexure bearing relies on the bearing element being made of a material which can be repeatedly flexed without disintegrating. However, most materials fall apart if flexed a lot. For example, most metals will fatigue with repeated flexing, and will eventually snap. Thus, one part of flexure bearing design is avoiding fatigue. Note, however, that fatigue is important in other bearings. For example, the rollers and races in a rolling-element bearing fatigue as they flatten against each other. A rolling-element bearing is a bearing which carries a load by placing round elements between the two pieces
Flexure bearings can give very low friction and also give very predictable friction. Many other bearings rely on sliding or rolling motions, which are necessarily uneven because the bearing surfaces are never perfectly flat. A flexure bearing operates by bending of materials, which causes motion at microscopic level, so friction is very uniform. For this reason, flexure bearings are often used in sensitive precision measuring equipment.
Flexure bearings are not limited to low loads, however. For example, the drive shafts of some sports cars replace cardan universal joints with an equivalent joint called a rag joint which works by bending rubberized fabric. A universal joint, U joint, Cardan joint, Hardy- Spicer joint, or Hooke's joint is a A rag joint refers to certain flexible joints found on Automobiles They are typically found on Steering shafts that connect the Steering The resulting joint is lighter yet is capable of carrying hundreds of kilowatts, with adequate durability for a sports car.
Many flexure bearings are combined with other elements. For example, many motor vehicles use leaf springs. Originally called laminated or carriage spring, a leaf spring is a simple form of spring, commonly used for the suspension in The spring both holds the position of the axle as the axle moves (flexure bearing) and provides force to support the vehicle (springing). In many cases it is not clear where flexure bearing leaves off and something else takes up. For example, turbines are often supported on flexible shafts so an imperfectly-balanced turbine can find its own center and run with reduced vibration. A turbine is a rotary Engine that extracts Energy from a Fluid flow Seen one way, the flexible shaft includes the function of a flexure bearing; seen another, the shaft is not a "bearing".