The Cray-3 was a supercomputer intended to be Cray Research's successor to the Cray-2. A supercomputer is a Computer that is at the frontline of processing capacity particularly speed of calculation (at the time of its introduction Cray Inc ( is a Supercomputer manufacturer based in Seattle Washington. The Cray-2 was a vector Supercomputer made by Cray Research starting in 1985. The system was to be the first major application of gallium arsenide (GaAs) semiconductors in computing. Gallium arsenide ( GaAs) is a compound of two elements Gallium and Arsenic. The project was not considered a success, and only one Cray-3 was delivered. Seymour Cray moved onto the Cray-4 design, but the company went bankrupt before the project was completed. Seymour Roger Cray ( September 28, 1925 – October 5, 1996) was a U The Cray-4 was intended to be Cray Computer 's successor to the failed Cray-3 Supercomputer.
Work on the design started in the late 1980s at Cray's new lab in Colorado Springs, CO, where he had moved in order to avoid managerial oversight from Cray headquarters in Chippewa Falls, WI. The City of Colorado Springs is a Home Rule Municipality that is the County seat and most populous city of El Paso County, Colorado, Geography Chippewa Falls is located at (44934110 -91393228 According to the United States Census Bureau, the city has a total area of 11 This lab should not be confused with a prior attempt to start Cray Laboratories in Boulder, CO for the earlier Cray-2. Boulder is a Home Rule Municipality that is the County seat and most populous city of Boulder County, Colorado, in the United States The Cray-2 was a vector Supercomputer made by Cray Research starting in 1985. Cray had always attacked the problem of increased speed with three simultaneous advances: more functional units to give the system higher parallelism, tighter packaging to decrease signal delays, and faster components to allow for a higher clock speed. The Cray-2 had introduced a novel 3D-packaging system for its integrated circuits to allow higher densities, and it appeared that there was some room for improvement in this process. Microchipsjpg|right|thumb|200px|Microchips ( EPROM memory with a transparent window showing the integrated circuit inside But for the sort of 10x performance increases Cray demanded, packaging alone would not be enough.
The Cray-2 appeared to be pushing the limits of speed of silicon-based transistors at 4. Silicon (ˈsɪlɪkən or /ˈsɪlɪkɒn/ silicium is the Chemical element that has the symbol Si and Atomic number 14 In Electronics, a transistor is a Semiconductor device commonly used to amplify or switch electronic signals 1 ns (244 MHz), and it didn't appear that anything more than another 2x would be possible. Cray had intended to use gallium arsenide circuitry in the Cray-2, which would not only offer much higher switching speeds, but also used less energy and thus ran cooler as well. At the time, the state of GaAs manufacturing simply wasn't up to the task of supplying a supercomputer, however, but by the mid-1980s things had changed and Cray decided it was the only way forward. In the end he decided the only solution was to invest in a GaAs chipmaking startup, GigaBit Logic, and use them as their internal supplier.
This was an extremely risky move -- if the technology didn't pan out the project was doomed to fail. The Cray-2 had not been terribly successful, and since the company was also in the midst of developing the Cray Y-MP, management eventually decided that the Cray-3 should be put on "low priority" development. The Cray Y-MP was a Supercomputer sold by Cray Research from 1988, and the successor to the company's X-MP. This was not the first time this had happened to Cray, and as in the past he decided to form his own company. The result was Cray Computer Corporation supported to a large degree by his major customer, NCAR. Cray Inc ( is a Supercomputer manufacturer based in Seattle Washington. The National Center for Atmospheric Research ( NCAR) is a non-governmental U
As with previous designs, the core of the Cray-3 consisted of a number of "modules", each containing several circuit boards packed with parts. In order to increase density, the individual GaAs chips were not "packaged", and instead several were mounted directly with ultrasonic gold bonding to a 4"x4" board. The boards were then turned over and mated to a second board carrying the electrical wiring, with wires on this card running through holes to the "bottom" (opposite the chips) side of the chip carrier where they were bonded. The result was a single 4x4 card with the chips sandwiched in the middle of two thin boards. These "submodules" were then stacked 4-deep, and as in the Cray-2, wired to each other to make a 3D circuit. Unlike the Cray-2, the Cray-3 modules also included edge connectors along the sides, and 16 such submodules were connected together to make a single 16"x16"x. 75" module. Even with this advanced packaging the circuit density was low even by 1990s standards, at about 100 gates per cubic inch. Modern CPUs offer gate counts of millions per square inch, and the move to 3D circuits is still just being considered.
Thirty-two such modules were then stacked and wired together with a mass of twisted-pair wires into a single processor. The modules were held together in an aluminum chassis known as a "brick". The bricks were immersed in liquid fluorinert for cooling, as in the Cray-2. Fluorinert is the trademarked brand name for the line of electronics coolant liquids sold commercially by 3M. A four-processor system dissipated about 88 kW of power. The entire four-processor system was about 20" tall and front-to-back, and a little over two feet wide. The processors sat at the top of a 3 by 3 by 4 foot cabinet, with the memory below it, and then the power supplies and cooling systems on the bottom. All in all the Cray-3 was considerably smaller than the Cray-2, itself relatively small compared to other supercomputers.
The basic cycle time was 2. 11 ns, or 474 MHz, allowing each processor to reach about 0. 948 GFLOPS, and the machine as a whole 15. Measuring performance In order for FLOPS to be useful as a measure of floating-point performance a standard benchmark must be available on all computers of interest 17 GFLOP. Key to the high performance was the high-speed access to main memory, which allowed each process to burst up to 8 GB/s.
Development dragged on, and serial number 1 was not delivered to NCAR until May 1993. Although the original design called for machines with 1 to 16 processors, NCAR's model included 4 and included a 128-MWord (64-bit words, 6GB) main memory. In production it was learned that the square root code contained a bug, and one of their four CPU's was not running reliably. Replacements to fix both problems were provided, but apparently not delivered. NCAR had not yet paid for the machine, and CCC folded in 1995 after burning through about 300 million dollars of financing. NCAR's machine was officially decommissioned the next day, but in fact two of the processors were removed, and the machine was used unofficially for some time after that.
Seven "tanks" were built for Cray-3 machines (most for smaller two-CPU machines), but NCAR's was the only one ever delivered. Three of the smaller tanks were used on the Cray-4 project, essentially a Cray-3 with 64 faster CPUs running at 1 ns (1 GHz). The Cray-4 was intended to be Cray Computer 's successor to the failed Cray-3 Supercomputer. Another was used for the Cray-3/SSS project. The Cray-3/SSS was a pioneering Massively parallel Supercomputer project that bonded a Cray-3 to a new SIMD processing unit based entirely in
The failure of the Cray-3 seems to have little to do with the machine itself, however, and everything to do with the changing political and technical climate. The machine was being designed during the collapse of the Warsaw Pact and ending of the cold war, which led to a massive downsizing in "large machine" supercomputer purchases. The Warsaw Pact (see Nomenclature) was an organization of Communist states in Central and Eastern Europe. Cold War is the state of conflict tension and competition that existed between the United States and the Soviet Union (USSR and their respective allies from the At the same time, the market was increasingly investing in massively parallel designs. Massively parallel is a description which appears in computer science life science medical diagnostics and other fields Cray was always a critic of this approach, and was quoted by the Wall Street Journal as saying that MPP systems have not yet proven their supremacy over vector computers, noting the difficulty many users have had programming for large parallel machines. "I don't think they'll ever be universally successful, at least not in my lifetime," a statement that became true only due to his untimely death in a car accident.
References
External links
- Greywolf, NCAR's Cray-3
- Digibarn's Cray-3 Modules
Dapyx Software network: MP3 Explorer | Ebook Manager | Zenithic